Buckeye Trucks for Pope Crane DES

Buckeye Trucks for Pope Crane DES

Buckeye 33 inch Friction Bearing Trucks for my Pope Rail Crane. These trucks are created with the origin at the center of the wheel on the Z Axis and aligned to the center of the bolster for the X and Y axis. You will need the truck/bogey attachment points aligned to the center of the bolster and at a height of 16.5 inches. This truck/bogey may be used on any freeware content. It is equipped with LOD, bump mapping, animation and a shadow mesh. If you wish to use this on payware, please contact me.

Author: LilB(Brian Snook)

Buckeye Trucks for Pope Crane DES
• anim.kin 4.09KB
• brakes.im 125.50KB
• brakes.kin 4.65KB
• buckeye.im 701.99KB
• buckeye.lm.txt 211 bytes
• buckeye.texture.txt 30 bytes
• buckeye.tga 3.00MB
• buckeye_bump.texture.txt 60 bytes
• buckeye_bump.tga 3.00MB
• buckeyelow.im 201.46KB
• buckeyemid.im 541.02KB
• config.txt 2.06KB
• thumbnail.jpg 32.20KB

VE107: The high-detail meshes total more than 10000 polygons. This may have a negative impact on performance: 0: 11468, 1: 8537, 2: 3673
VE109: The low-detail meshes total more than 500 polygons. This may have a negative impact on performance: 0: 11468, 1: 8537, 2: 3673