USRA Light 2-8-2 e-spec - Cab Driver Ver.
<kuid:123250:100042>
Author: | wva-usa |
Kind: | steam-engine |
Build: | 2.9 |
Size: | 68.75KB |
Uploaded: | 2023-12-25 |
Web-site: | wvrailroads.net |
Loadings: |
38
-
+
|
USRA Light 2-8-2 e-spec - Cab Driver Ver.
This e-spec was made specifically for driving steam locomotives in CAB MODE -- not recommended for DCC/AI use. See http://steamsoundz.com/e-specs for instructions regarding coal levels to use when running locos with this e-spec, as it may require a different technique that what you're accustomed to to using. If these methods are followed you should have minimal problems with keeping the boiler temperatures under control and have minimal problems with safety valves lifting.
This is a TS2009/TS2010/TS12 steam enginespec (e-spec) designed for Ben Neal's USRA Light Mikado (2-8-2) locomotive that enables it to pull approximately the same number of cars pulled by the real 2-8-2s, e.g. about fifty 55 ton cars (plus caboose) on level track and up .5-percent grade. Braking capacity has been slightly increased to allow for better handling of l-o-n-g trains down steep grades.
Author: C. Lloyd Gibson
- USRA Light 2-8-2 e-spec - Cab Driver Ver.
- config.txt 7.28KB
- screenshot.jpg 64.33KB
Copyright © 2012-2013 by C. Lloyd Gibson -- All Rights Reserved. License is hereby given for Trainz content creators to make use of this enginespec in its original form in freeware Trainz models -- for use with commerical models or any other use, please e-mail me requesting permission. Do not sell, repackage, or redistribute the files, in whole or part, without written permission.
VE48: This asset uses an obsolete trainz-build number. Trainz-build numbers below 3.5 are no longer supported.
User photos
No one has added a photo of this object yet
Comments:
Sign in to post a comment