MRBK Guard Rail

MRBK Guard Rail

Moffat Road Bridge Kit

Guard Rail

Spline that can be used as a set of guard rails (check rails) when placed on top of normal rail tracks.
Hit F4 to use straighten tool on this, if needed.

Works best when laid directly on top of track spline points, and when end sections are over straight track.
If an end section must be inside a curve, extra spline points may be needed near the end to get an acceptable result.

Guard Rail Weight: 80#
Guard Rail Gauge: 2ft 7½in (10in between outer face of guard rail and inner face of running rail)
Main Mesh Length: 2m
End Mesh Length: 4.622m

Poly Counts (gmax)
Middle: 12
Ends: 51

Suggestions for improvement are welcome!

Author: Eric Jacobsen

MRBK Guard Rail
• config.txt 3.05KB
• license.txt 731 bytes
• mrbk_guard_rail.im 1.34KB
mrbk_guard_rail_ends
mrbk_guard_rail_ends.im 3.71KB
rail3.texture.txt 31 bytes
• rail3.texture.txt 26 bytes
• rail3.tga 4.04KB

This Content Asset was originally created by Eric Jacobsen.
email address: [email protected]
Auran Username: eejacobsen
Auran User ID: 126054

No warranty of any kind is granted or implied with this Content Asset. Eric Jacobsen may not be held responsible for any damages of any kind that result from discovering, acquiring, installing, using, or referencing this Content Asset.

Permission is granted to use or reference this Content Asset as part of any 'freeware' Route.

Any other use, redistr

VE48: This asset uses an obsolete trainz-build number. Trainz-build numbers below 3.5 are no longer supported.
VE62: Required container 'thumbnails' is missing.