TCDrivePastJunction

TCDrivePastJunction

A driver command for throttle-controlled custom driving beyond a selected JUNCTION. The procedure is as follows. (1) Navigate the train's way to the selected JUNCTION either by manually switching the junctions or by using Mutton's PATH rule and SETPATH command. (2) Use ResetTrainDirection, SwitchDCCGear, and/or SetDCCThrottle commands if necessary to set the train to correct moving direction and desired throttle speed. (3) Apply TCDrivePastJunction command to drive the train past the JUNCTION. Depending on the menu choices, the driver schedule command ends on two occurrences. If 'InnerLeave' option is chosen along with the JUNCTION, the schedule will end as soon as the entire train leaves the JUNCTION. On the other hand, if 'Leave' option is chosen with the JUNCTION, the schedule will end once the entire train leaves the JUNCTION's trigger area at some radius.

VERSION 0.0
PREREQUISITE: SetDCCThrottle command
OPTIONAL: ResetTrainDirection, SwitchDCCGear
RECOMMENDED: Mutton's PATH rule and SETPATH command.
NOTES: Check out SetDCCThrottle command to find out how you adjust throttle level. A throttle level must previously be issued by SetDCCThrottle command before using this command; otherwise, your train may not move.

This command comes with Shuntn' and Cruisn' Pack, Number 3, which includes

TCDriveViaTrackmark2, TCDriveViaTrigger, TCDrivePastJunction,
SplitConsist, and APSetTrainDirection

Also, Shuntn' and Cruisn' Pack, Number 2 contains

VCDriveViaTrackmark2, VCDriveViaTrigger, VCDrivePastJunction,
APDriveViaTrackmark, APDriveViaTrigger, APDrivePastJunction,
StopTrain

and the original pack contains
VCDrive, VCDriveViaTrackmark, VCDriveToTrackmark, VCouple,
TCDrive, TCDriveViaTrackmark, VCDriveToTrackmark, TCouple,
SetDCCThrottle, SwitchDCCGear, ResetTrainDirection, SetTargetSpeed,
DefineSpeedProfile, CommWithTTable, and WorkTable (rule)

Author: atilabarut

TCDrivePastJunction
• config.txt 2.96KB
• shuntnandcruisnpack.jpg 10.23KB
• tag.tga 64.04KB
• tcdrivepastjunction.texture.txt 41 bytes
• tcdrivepastjunctioncommand.gs 2.80KB
• tcdrivepastjunctionschedulecommand.gs 4.34KB

VE48: This asset uses an obsolete trainz-build number. Trainz-build numbers below 3.5 are no longer supported.