TCDriveToTrackmark

TCDriveToTrackmark

A driver command to perform throttle-controlled custom driving to a selected trackmark (Version 1.0). The procedure is as follows. (1) Navigate to the selected trackmark by using Mutton's PATH rule and SETPATH command. (2) Use ResetTrainDirection, SwitchDCCGear, and/or SetDCCThrottle commands (available on DLS) if necessary to move your train in the right direction and desired throttle-speed. (3) Apply TCDriveToTrackmark coommand to drive the train to the trackmark. The driver (schedule) command ends once your train comes to a full stop at the trackmark. Make sure that correct trackmark is chosen from the menu.


VERSION: 1.0
PREREQUISITE: SetDCCThrottle
OPTIONAL: ResetTrainDirection, SwitchDCCGear
RECOMMENDED: Mutton's PATH rule and SETPATH command
NOTES: This command supercedes the old DCCDriveToTrackmark V0.0 driver schedule command. DCCDriveToTrackmark V0.0 is no longer consistent with the current pack and therefore it is highly recommended to download the whole pack, available on DLS, in order to avoid any incompatibilities.

Author: atilabarut

TCDriveToTrackmark
• config.txt 2.12KB
• shuntnandcruisnpack.jpg 10.22KB
• tag.tga 64.04KB
• tcdrivetotrackmark.texture.txt 41 bytes
• tcdrivetotrackmarkcommand.gs 2.25KB
• tcdrivetotrackmarkschedulecommand.gs 3.66KB

VE48: This asset uses an obsolete trainz-build number. Trainz-build numbers below 3.5 are no longer supported.