Route selector 2 (Multi-path)

Route selector 2 (Multi-path)

Version 2015-06-23. Allows the path of a train to be set on reaching this trackside object. Multiple junctions can be specified and the path of each train can vary according to which waypoint destination markers are selected in the session.
By using the driver command - Set Waypoint, a list of waypoints can be added to each train. When the train reaches a destination waypoint the list is updated to remove the waypoint at the head of the list.
The selector only triggers when the train is travelling in the same direction as the arrow shows and the current destination waypoint matches one of the destinations held in the selector. Trains with no waypoint list will not trigger the route selector.

Multiple paths can be set to route trains to different paths.

If the Set Waypoint command option specifies 'Wait for Leave' then the specified junctions will be set when the train leaves the waypoint mark, otherwise the junctions are set when the selected delay has elapsed.

The mesh and images used in this asset were found in L_a2_PAV_Junction Switch originally created by Petr Kubik. Attempts to contact Petr have failed.
Thanks to user TRAMP for providing the name attachment.

Author: Trevor Laughton

Route selector 2 (Multi-path)
• color.texture.txt 28 bytes
• color.tga 812 bytes
• config.txt 6.00KB
images
center.tga 1.21KB
centerg.tga 1.21KB
deljn.tga 1.19KB
deljng.tga 1.19KB
left.tga 1.21KB
leftg.tga 1.21KB
right.tga 1.21KB
rightg.tga 1.21KB
• jehlan.im 1.09KB
• routeselector.gs 34.87KB
• screenshot.jpg 6.22KB

Freeware. No warranty. Commercial use not allowed without author's permission.