VR Type 'A' Water Tower - 1c

VR Type 'A' Water Tower - 1c

This is a model of a typical, VR 'A' type, all steel Water Tower of a smaller than normal 6000 gallons capacity, only. This model is textured to represent a relatively 'older' (slightly rusted) installation that was originally painted in the VR's Oxide Red scheme. These units were located throughout the state of Victoria and used primarily at smaller terminal locations and locomotive depots, where the larger 10,000 gallon Towers (available separately by the same author) would have been ''inappropriate''. The model is intended for use in Trainz version TS2009 or later.

Author: Jerker

VR Type 'A' Water Tower - 1c
• $screenshot$.jpg 19.08KB
• concrete_cast-in-place_flat_grey-normals.texture.txt 88 bytes
• concrete_cast-in-place_flat_grey-normals.tga 193.04KB
• concrete_cast-in-place_flat_grey.texture.txt 55 bytes
• concrete_cast-in-place_flat_grey.tga 193.04KB
• config.txt 1.70KB
• dirty water-normals.texture.txt 67 bytes
• dirty water-normals.tga 769.04KB
• dirty water.texture.txt 34 bytes
• dirty water.tga 769.04KB
• large_round_steel_red-normals.texture.txt 77 bytes
• large_round_steel_red-normals.tga 1.50MB
• large_round_steel_red.texture.txt 44 bytes
• large_round_steel_red.tga 1.50MB
• tower.im 907.37KB

VE48: This asset uses an obsolete trainz-build number. Trainz-build numbers below 3.5 are no longer supported.
VE107: The high-detail meshes total more than 10000 polygons. This may have a negative impact on performance: 0: 12978
VE109: The low-detail meshes total more than 500 polygons. This may have a negative impact on performance: 0: 12978