Hicapyflat 10 Body

Hicapyflat 10 Body

This represent a very large casting assembly which is too long and too heavy for a single 4 bogey flatcar and must be
suspended between two 4-bogey flatcars. Assemble this car in Surveyor as follows:
1. Place Hicapyflat_10_Body on the track.
2. Place two Hicapyflat_9_Bodys on the track a little bit past the ends of Hicapyflat_10_Body (not underneath).
3. Rotate one of the Hicapyflat_9_Bodys to get the brake wheel out of the load.
4, Place 2 Hicapyflat_Bolsters under each Hicapyflat_9_Body by placing them about half way between the center of the body and each end.
5. Move the Hicapyflat_9_Body assemblies under Hicapyflat_10_Body.
6. If all went well there will only 1 red and 1 green arrow and the item will move as a unit.

Hicapyflat 10 Body
• config.txt 2.54KB
• hicapyflat_10_body.im 263.68KB
• metal6.jpg 47.37KB
• metal6.texture.txt 29 bytes
• rust8.jpg 36.69KB
• rust8.texture.txt 28 bytes
• wood2.jpg 121.70KB
• wood2.texture.txt 28 bytes