NASA SRB Car 2

NASA SRB Car 2

This is the body section (the pic shows the complete car) of an interactive articulated
special purpose flat car (lettered for the Florida East Coast Railroad) with four 4-wheel roller bearing bogeys.
There are two attachment points (a.load0 and a.load1) in the center of the car. They will load NASA_SRB_Load_1
(kuid2:210518:6539:1) or NASA_SRB_Load_2 (kuid2:210518:6543:1) but not both at the same time. Many thanks
to Conn McCarthy for the use of his 36in 100t Trucks. Assemble this car in Surveyor as follows:
1. Place NASA_SRB_Car_1 (this item) on the track.
2. Place one NASA_SRB_Front_Bolster on the track beyond end of the body with the foreward arrow.
3. Place one NASA_SRB_Car_Rear_Bolster on the track beyond the other end of the car.
4. Rotate one bolster 180 degrees to get the coupler facing outward.
5. Move the bolsters under the ends of the body.
6. When properly assembled there will only be 1 red and 1 green arrow and the car will move as a unit.

Author: Benjamin R. Dorsey

NASA SRB Car 2
• brass.bmp 822 bytes
• brass.texture.txt 28 bytes
• config.txt 7.13KB
• nasa_srb_carbody_2.im 42.34KB