UZ Move to train

UZ Move to train

This command moves the driver to another train, either by a driver command which is added to the current schedule or immediately, deleting all pending commands. When a Move To command is added to the schedule all pending commands are copied to the new train and will be executed there.

The command has three submenus:

All trains: lists the frontmost loco of all consists on the layout and adds a Move To command for the selected loco. If the loco has a driver when the command is executed the driver issues a warning message and waits until the other driver leaves the train.

Trains without driver: same as above, but lists only consists that have no driver.

Move immediately: lists only consists that have no driver and moves immediately to the new train, deleting all pending commands.

Author: OlegKhim

UZ Move to train
• config.txt 17.08KB
• dls.jpg 52.46KB
• move.tga 16.04KB
• permescastcom.gse 649 bytes
• permestpravcom.gse 725 bytes
• permesvpoezdcom.gse 1.76KB

VE61: Required tag 'properties-behavior' was missing and has been set to default.