Ardglen tunnel bore and portals, NSWGR

Ardglen tunnel bore and portals, NSWGR

This is a single-track tunnel with portals at both ends based on the tunnel under the Liverpool Range at Ardglen, NSW.

To install this tunnel, run a no-ballast track spline underground on the tunnel path. Then run this spline along the same path and adjust the height at spline points to leave only the tops of sleepers visible. Add spline points along its length if additional adjustment to the tunnel's gradient and/or curvature is required.

Use matching asset '<kuid:368725:20550> Ardglen tunnel portal dighole cover' to close gaps at the sides of and above the portals.

Ardglen tunnel bore and portals, NSWGR
• config.txt 3.16KB
• thumbnail.jpg 37.22KB
• tunnel_albedo.png 3.95MB
• tunnel_albedo.texture.txt 34 bytes
• tunnel_bore_0.trainzmesh 9.37KB
• tunnel_bore_1.trainzmesh 5.50KB
• tunnel_normal.png 4.84MB
• tunnel_normal.texture.txt 86 bytes
• tunnel_parameters.png 121.85KB
• tunnel_parameters.texture.txt 69 bytes
• tunnel_portal_a0.trainzmesh 38.84KB
• tunnel_portal_a1.trainzmesh 15.05KB
• tunnel_portal_b0.trainzmesh 38.84KB
• tunnel_portal_b1.trainzmesh 15.05KB