VR ESX T2c - 1971+

VR ESX T2c - 1971+

The Victorian Railways ESX Wagons where built at Ballarat Workshops from July 1964 to July 1965 and Newport Workshops from April to Augest 1965, a total of 26 where built, these wagons where built for bogie exchange Steel traffic between Vic, NSW, SA and WA, this rarely happened and instead these wagons mostly stayed on the Broad Gauge and would get loads swapped between other wagons. they where put into Pipe and Swan Timber traffic and where thrown all over Victoria. In 1971 they where modified with longer draw gear and coupler shanks, ESX 15 had C channels welded on the tops to extend the height of the Stanchions for Pipe traffic.

This Model represents ESX 15 on Broad Gauge in modified condition from Spetember and October 1971, Step's created by Zec.

Mass: 21-5-0-7 (empty) 71-5-0-7 (loaded)
Load Capacity: 50 Tons Distributed
Max Speed: 60mph
Axle Load: 17-16-0-30
Brake Cylinder: (1) 12in x 12in Air slack Adjuster
Brake Ratio: 34.9% (Loaded) ~ 63.4% (Empty) Load Compensating

Author: Azervich

VR ESX T2c - 1971+
• config.txt 8.72KB
• icon.tga 6.04KB
• mass to kg.txt 349 bytes
• screenshot.jpg 50.31KB
shadow
shadow.im 83.82KB
shadow.lm.txt 134 bytes
• wagon.gs 22.42KB
wagon_body
alpha-alpha.texture.txt 60 bytes
alpha.tga 128.04KB
grade-control-lever.im 17.04KB
grade-control-lever.kin 2.33KB
grade-control-lever.lm.txt 147 bytes
groundplane-groundplane.texture.txt 70 bytes
groundplane.tga 128.53KB
load-compensating-lever.im 20.46KB
load-compensating-lever.kin 4.09KB
load-compensating-lever.lm.txt 151 bytes
main-env.tga 12.00MB
main-main-env.texture.txt 49 bytes
main-normals.texture.txt 83 bytes
main-normals.tga 12.00MB
main-spec.tga 12.00MB
main.tga 12.00MB
mesh-step-env.tga 192.04KB
mesh-step-mesh-step-env.texture.txt 59 bytes
mesh-step-normals.texture.txt 93 bytes
mesh-step-normals.tga 192.04KB
mesh-step-spec.tga 192.04KB
mesh-step.tga 192.04KB
wagon.lm.txt 286 bytes
wagon_highest.im 1.25MB
wagon_low.im 307.04KB
wagon_lowest.im 2.79KB
wagon_mid.im 976.30KB