CHN SS3 bogie shuidi pbr

CHN SS3 bogie shuidi pbr

The bogie frame adopts steel plate welded structure. The traction motor transmits the force to the wheel pair through gears, and then transmits the force to the bogie frame through the axle box pull rod, and the bogie transmits the force to the vehicle body through the non-bearing center pin. The axle box is of roller bearing type without guide frame. Two axle box pull rods with rubber elements are connected with the frame to make the axle box and the frame relatively move within a certain range. The traction motor is installed in a semi-suspended manner, and one side of the traction motor is supported on the wheel pair through a holding bearing; The other side is suspended from the frame beam by rubber elements.

Author: b2snpower

CHN SS3 bogie shuidi pbr
• abog.lm.txt 206 bytes
• abog.trainzmesh 3.35MB
• anim.kin 5.32KB
• bog_albedo.texture.txt 31 bytes
• bog_albedo.tga 12.00MB
• bog_normal.texture.txt 89 bytes
• bog_normal.tga 12.00MB
• bog_parameter.texture.txt 92 bytes
• bog_parameter.tga 16.00MB
• config.txt 2.83KB
• sdl_07 - default_albedo.texture.txt 44 bytes
• sdl_07 - default_albedo.tga 3.00MB
• sdl_07 - default_normal.texture.txt 102 bytes
• sdl_07 - default_normal.tga 3.00MB
• sdl_07 - default_parameter.texture.txt 118 bytes
• sdl_07 - default_parameter.tga 4.00MB
• thumbnail_0.jpg 60.50KB

VE107: The high-detail meshes total more than 10000 polygons. This may have a negative impact on performance: 0: 40898, 1: 0