RRC 1a BR 9F

RRC 1a BR 9F

This session is for RiversideRailroadCompany 1a. All the items of rolling stock needed by the session will be downloaded from the Download Station when the session is installed. However, make sure that all the dependencies needed by the double chimney 9F locomotive are installed, including all the dependencies needed by the cab and the skin for the loco crew, kuid 44090:57003, that Download Helper or CMP might not capture

Charlie and Eddie, Control here.
Water and coal your 9F, then couple onto the bolsters next to Conoco.
Load the bolsters with coil at Hymill-Write and proceed to Lys.
On the approach to Lys unload and leave the bolsters at the overhead crane at Fingers Foundry.
On the lower level at Lys fill the hoppers with coal at the gantry and return with the hoppers to Diaspar. Unload four of the hoppers at Alan's Multifunctional and leave all the hoppers in the northern Transfer Yard.
Return to loco and sign off.
You must always give way to mainline trainz.
You are authorised to travel at up to 50mph except in yard areas where normal limits apply.
You are authorised to stop when necessary for locomotive purposes.

This session is intended to be driven in Cab Mode. For those unfamiliar with driving a steam locomotive in Cab Mode detailed instructions can be found in the readme and here:

http://forums.auran.com/trainz/showthread.php?t=9845&highlight=passedasdriver

Note that the coal and water capacity of the tender have be modified; one of the challenges in this session is to arrive at the destinations with water remaining in the tender.

Maps and a readme are included in the folder containing the session.

Author: philskene

RRC 1a BR 9F
• config.txt 3.93KB
• diaspar_1.jpg 90.58KB
• diaspar_2.jpg 90.26KB
• diaspar_3.jpg 87.94KB
• lys_1.jpg 88.54KB
• lys_2.jpg 89.77KB
• lys_3.jpg 89.23KB
• profile.dat 978.86KB
• readme.htm 12.92KB
• readme.txt 12.01KB
• riversiderailroadco_map.jpg 89.54KB
• rrc1a_br_9f_small.jpg 18.15KB