Move to train

Move to train

This command moves the driver to another train, either by a driver command which is added to the current schedule or immediately, deleting all pending commands. When a Move To command is added to the schedule all pending commands are copied to the new train and will be executed there.

The command has three submenus:

All trains: lists the frontmost loco of all consists on the layout and adds a Move To command for the selected loco. If the loco has a driver when the command is executed the driver issues a warning message and waits until the other driver leaves the train.

Trains without driver: same as above, but lists only consists that have no driver.

Move immediately: lists only consists that have no driver and moves immediately to the new train, deleting all pending commands.

Author: Martin Hammel (_mutton_)

Move to train
• config.txt 17.80KB
• dls_thumbnail.jpg 9.24KB
• movecustomcommand.gse 695 bytes
• moveschedulecommand.gse 813 bytes
• movetotrain.bmp 12.05KB
• movetotrain.texture.txt 58 bytes
• movetotrain.tga 12.02KB
• movetotraincommand.gse 2.55KB
• screenshot.jpg 9.24KB

VE48: This asset uses an obsolete trainz-build number. Trainz-build numbers below 3.5 are no longer supported.