Reinforced Ballast Wall

Reinforced Ballast Wall

A spline of a Reinforced Ballast Retaining Wall, to suit chuffbuffs QR track, with Ballast fill behind the wall. The height above ground is nominally 6 metres, with 3 metres below ground, but it is height adjustable and may be raised from or sunk into the ground for a different structure height.
Use the shift key to prevent splines joining to previously placed ones, and if you place it in short lengths, the sloping end wall does not appear.
Skewed panels are not used in practice because of the layer placement process, so when the height is adjusted, The panels must remain square to be realistic.
The wall is made from concrete interlocking facing panels, and relies on metal or other durable material straps attached to the rear of the wall and extending 6 metres or more into the fill, depending on wall height. The wall is constructed upwards with the straps placed between incremental layers of fill, The wall relies on the friction of the soil on the straps to give friction resistance to prevent the panels bulging.
Consequently, the wall must be used with fill behind. It is not a free standing wall.
This replaces a previous model for TRS compatability.
Once installed you will find it as Reinforced Earth Wall under splines in the Australia listing.

Author: alby6

Reinforced Ballast Wall
• ballast.tga 64.04KB
• concrete10.texture.txt 33 bytes
• concrete10.tga 12.53KB
• config.txt 3.42KB
enda
ballast.tga 64.04KB
concrete10.texture.txt 33 bytes
concrete10.tga 12.53KB
enda.im 2.95KB
grass.texture.txt 30 bytes
rewall7.texture.txt 30 bytes
rewall7.tga 192.53KB
endb
ballast.tga 64.04KB
concrete10.texture.txt 33 bytes
concrete10.tga 12.53KB
endb.im 2.95KB
grass.texture.txt 30 bytes
rewall7.texture.txt 30 bytes
rewall7.tga 192.53KB
• grass.texture.txt 30 bytes
• rewall.im 2.94KB
• rewall7.texture.txt 30 bytes
• rewall7.tga 192.53KB
• thumb.jpg 21.93KB