CHN DF5 bogie pbr

CHN DF5 bogie pbr

The bogie frame adopts steel plate welded structure. The traction motor transmits the force to the wheel pair through gears, and then transmits the force to the bogie frame through the axle box pull rod, and the bogie transmits the force to the vehicle body through the non-bearing center pin. The axle box is of roller bearing type without guide frame. Two axle box pull rods with rubber elements are connected with the frame to make the axle box and the frame relatively move within a certain range. The traction motor is installed in a semi-suspended manner, and one side of the traction motor is supported on the wheel pair through a holding bearing; The other side is suspended from the frame beam by rubber elements.

Author: Meiarail

CHN DF5 bogie pbr
• anim.kin 5.16KB
• bog.fbx 2.43MB
• bog.trainzmesh 6.85MB
• config.txt 2.04KB
• jiazialbedo.texture.txt 32 bytes
• jiazialbedo.tga 3.00MB
• jiazinormal.texture.txt 90 bytes
• jiazinormal.tga 3.00MB
• jiaziparameter.texture.txt 94 bytes
• jiaziparameter.tga 4.00MB
• lunzialbedo.texture.txt 32 bytes
• lunzialbedo.tga 1.00MB
• lunzialbedo1.tga 768.04KB
• lunziparameter.texture.txt 94 bytes
• lunziparameter.tga 1.00MB
• lunzirgb.texture.txt 87 bytes
• lunzirgb.tga 768.04KB
• n3cbog.lm.txt 205 bytes
• thumbnail_0.jpg 44.77KB

VE48: This asset uses an obsolete trainz-build number. Trainz-build numbers below 3.5 are no longer supported.
VE107: The high-detail meshes total more than 10000 polygons. This may have a negative impact on performance: 0: 103964
VE109: The low-detail meshes total more than 500 polygons. This may have a negative impact on performance: 0: 103964